301GAS Commercial Gas Burner

Power Gas Burner 401,000 to 1,100,000 BTUH

[Photo] 301 GAS burner
The 301GAS burner converts from propane to natural gas with just an orifice change – no conversion kit needed. Fires negative or positive chambers from 401,000 to 1,100,000 Btuh input. Time-tested solid state ignition and state-of-the-art microprocessor primary control technology. Diagnostic LED lights annunciate operating mode: Self-check, Flame-on, Recycle, Lockout and Latch-up. Factory-packaged with combustion control and gas train (assembed, shipped loose; also available as knockdown). Shipped completely pre-wired for easy installation and start-up (knockdown version also available). High-efficiency, compact flame pattern design ensures clean, quiet operation. Does not require a refractory liner – fires with or without a combustion chamber. Swing-away flanged door design.

Input
“B” Head/Tube 401,000 to 700,000 Btuh

“C” Head/Tube 550,000 to 1,100,000 Btuh

Fuels Natural Gas or Propane Gas

Maximum Supply Pressure: 14 inches w.c.

Minimum Supply Pressure: 5.0 inches w.c.

Manifold Pressure: 3.5 inches w.c.

Control
Carlin 60200FR Microprocessor Control
4 sec. Trial for Ignition (TFI)
1.3 Sec. FFRT

Pre-purge and post-purge
Serviceman Reset Protection
Latch-up after three consecutive lockouts
Interrupted Duty Ignition
Recyle on Flame Failure
Electrical Power: 120 vac/60Hz/1-Phase

Current: Approximately 2.5 amps

Limit Circuit Input: 120 vac/60 Hz

Motor: 1/6 HP, 3450 RPM, 60 Hz

Motor Frame: 48 Frame, “N” Flange

Fuel Valve Power: 120 vac/60 Hz

Ignition Carlin Model 41800 solid state electronic ignition

Ignition Voltage: 9,000 volts

Orifice Selection Contact Carlin
Agencies UL Listed: US